WAVE NOUVEAU TEXTURIZING SYSTEM SHAPE TRANSFORMER [STEP 2] 15.5 oz
Step 2 in the Wave Nouveau® Coiffure system, Shape Lock effectively locks hair into a new configuration by oxidizing and reforming hair that has been reduced to its new shape. Use after Shape Release.
APPLICATION
- Wear suitable, disposable gloves.
- Do not brush or comb hair vigorously prior to using this product.
- Shampoo hair gently and towel-dry. Do not rub scalp.
- Wrap hair on rods without excessive tension.
- Apply the Conditioning Wave Lotion only after wrapping in completed.
1. After straightening patron's hair with Step 1 Shape Release, rinse hair well with tepid water. Towel blot dry.
2. Section the hair for wrapping. Using desired rods apply Step 2 Shape Transformer to each section of hair. Reapply Step 2 Shape Transformer as needed to keep hair from drying out.
3. Upon completion of the wrap, blot away any excess product. Place a cotton strip around the hairline and a processing cap over the entire head. Allow Step 2 Shape Transformer to proceed for 10 minutes.
4. After 10 minutes processing time, remove cap and cotton and check for sufficient S pattern. If desired wave pattern is set, rinse hair thoroughly for 5 to 10 minutes using tepid water. If the desired wave pattern is not achieved, replace cap and check again every 3 minutes.
5. After rinsing thoroughly, towel blot each individual rod to eliminate any excess water left in hair.
6. Apply Step 3 Shape Lock and follow directions carefully.
Step 2 in the Wave Nouveau® Coiffure system, Shape Lock effectively locks hair into a new configuration by oxidizing and reforming hair that has been reduced to its new shape. Use after Shape Release.
APPLICATION
- Wear suitable, disposable gloves.
- Do not brush or comb hair vigorously prior to using this product.
- Shampoo hair gently and towel-dry. Do not rub scalp.
- Wrap hair on rods without excessive tension.
- Apply the Conditioning Wave Lotion only after wrapping in completed.
1. After straightening patron's hair with Step 1 Shape Release, rinse hair well with tepid water. Towel blot dry.
2. Section the hair for wrapping. Using desired rods apply Step 2 Shape Transformer to each section of hair. Reapply Step 2 Shape Transformer as needed to keep hair from drying out.
3. Upon completion of the wrap, blot away any excess product. Place a cotton strip around the hairline and a processing cap over the entire head. Allow Step 2 Shape Transformer to proceed for 10 minutes.
4. After 10 minutes processing time, remove cap and cotton and check for sufficient S pattern. If desired wave pattern is set, rinse hair thoroughly for 5 to 10 minutes using tepid water. If the desired wave pattern is not achieved, replace cap and check again every 3 minutes.
5. After rinsing thoroughly, towel blot each individual rod to eliminate any excess water left in hair.
6. Apply Step 3 Shape Lock and follow directions carefully.